![]() ![]() Some of these could be caused by damage during shipping, some could be damage during installation, and some happen due to a faulty part. We have put together a list of some of the clear signs that you have a defective or damaged LCD. With that said, there are other issues that we see pop up that sadly, cannot be fixed by any troubleshooting. These steps cover the most common questions we get regarding screen replacements. There may be some sticky 3M tape or glue residue that you will need to remove before attempting to reinstall your new screen. We suggest removing the LCD assembly, and thoroughly clean the metal frame of all glass, glue, and tape. Pressure can also come from placing your finger directly on the back of the LCD screen. Pressure could be caused by small pieces of glass that may have been left behind from your broken screen, and they adhere to your mid-frame. These are caused by too much pressure being applied to the LCD. Any yellow discoloration or ink like splotches are signs of stress marks. These can have several different variations. At this stage, your best solution will be to reassemble your device with your broken screen, and contact Apple about getting a new device all together. If the white screen persists after the soft reset, it could be a case of your device not wanting to accept a 3rd party part all together. Start with performing a soft reset on your device (hold down the top power and bottom home button until the device shuts down and reboots). Apple devices sometimes do not want to initially accept a new part. This is normally a software calibration issue. Close it up, and enjoy your device as Apple intended! Should an image appear on your phone, you are ready to go. In either case, your battery no longer is sending a strong enough charge to your phone to allow the screen to make an image appear. If no image appears, you have a battery that is dead or dying. Turn your device on using the power button.If an image appears, unplug your device from iTunes.Plug your device into iTunes (see if you have an image).If your device is still (or is just now) showing no image, but there is a glow from the back light, follow these steps: This will allow you to troubleshoot your repair without the need to remove every screw all over again. Once the pins are straight, and the screen is plugged in again, try powering on your device without closing it up. You will need to bend the pins back into place before your device will start working again. If the pins are damaged, plugging in your new screen again will not solve the problem. At the point where you plug in your new screen to your main board, check both your connector plugs, and verify that none of the pins are bent or missing. This is normally a sign of your LCD cable not being plugged in correctly. Blue/Black Bars, Half an Image, or No Image: Before we replace your screen assembly we ask that you try following these simple steps to fix your problem: 1. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |